R&M Materials Handling ELECTRIC CHAIN HOISTS LoadMate Chain Hoist LM 10 Stepless - Manual (Page 44)

LM10 STEPLESS I&M MANUAL/EN/11.30.2010
44/99
This document and the information contained herein, is the exclusive property of R&M Materials Handling, Inc., and represents a non-public, confidential and proprietary trade secret that
may not be reproduced, disclosed to third parties, altered or otherwise employed in any manner whatsoever without the express written consent of R&M Materials Handling, Inc.
Copyright © (2010) R&M Materials Handling, Inc. All rights reserved.
I3.8.3.3 Firmware interface
I3.8.3.4 System load
S3.8.4 Application info
A3.8.4.1 Application
A3.8.4.1.
1 Application id
A3.8.4.1.
2 Application version
A3.8.4.1.
3 Firmware interface
S3.8.5 Hardware info
I3.8.5.2 Unit voltage
I3.8.5.3 Brake chopper
I3.8.5.4 Brake resistor
S3.8.6 Options
S3.8.6.1 NXOPT
E3.8.6.1.
1 Status
E3.8.6.1.
2 Program version
S3.9 (not used)
S3.10 (not used)
M4 Active faults
The memory of active faults can store the maximum of 10 faults in the order of appearance.
By pushing the button you will enter the Fault history section.
M5 Fault history
The fault memory can store a maximum of 5 faults in the order of appearance. The number of faults currently in the fault history is shown on
the value line of the main page. The latest fault carries the indication H5.1, the second latest H5.2 etc. If there are 5 uncleared faults in the
memory, the next occurring fault will erase the oldest from the memory.
Pressing the Enter button for about 2 to 3 seconds resets the whole fault history.
Note 1: when one of listed motors is selected, Parameters group G1.2.4, G1.2.5 and
G1.2.6 are not viewable. Parameters group G1.2.4, G1.2.5 can be viewed after P1.2.2 is
set back to 1 ‘’free travel’’
Note 2: Parameters group G1.2.6 “Brake Control” can only be viewed when parameter
P1.2.2 is set to 13 “free hoist”