R&M Materials Handling ELECTRIC CHAIN HOISTS LoadMate Chain Hoist LM 10 Stepless - Manual (Page 64)

LM10 STEPLESS I&M MANUAL/EN/11.30.2010
64/99
This document and the information contained herein, is the exclusive property of R&M Materials Handling, Inc., and represents a non-public, confidential and proprietary trade secret that
may not be reproduced, disclosed to third parties, altered or otherwise employed in any manner whatsoever without the express written consent of R&M Materials Handling, Inc.
Copyright © (2010) R&M Materials Handling, Inc. All rights reserved.
7.12 Control Changes and Fuses
The layouts and wiring diagrams found within this section are for standard hoist controls. Stepless hoists are
available for 460 volt three-phase power supplies only.
Control Circuit Fuse
The control circuit fuse holder is located on terminal strip X1. The fuse holder top flips up to facilitate
changing a defective fuse.
Table 17. Control Circuit Fuse
POWER CONTROL FUSE
SUPPLY VOLTAGE SIZE
3 – PHASE 115 VAC 630 mA