Crown Audio IQ-MSD Turbo Software - Manual (Page 125)

IQ–MSD Turbo 1.4 Advanced IQ System Software
Page 125
5.4 Automated Controls
Some IQ P.I.P.s such as the IQ–P.I.P.–SMT and IQ–P.I.P.–DSP include features that, once configured, automati-
cally run without further supervision from the IQ System. These features, as a group, are referred to as
SmartAmp features. They can be configured from a Sub-block screen or from a graphics plate. However, this
section will focus on configuring them from a sub-block because it is a bit easier. To configure the SmartAmp
features from a graphics plate you can use a standard amplifier GDM or create a control, assign a SmartAmp
parameter to it and then set the parameter.
To switch to the Sub-block screen, select ASA in the control block of the desired amplifier and press E or Y.
(Remember, too, that the ASA control is used to enable or disable all automatic features in the sub-block. See
Section 5.3.1.) A typical amplifier Sub-block screen for a legacy IQ P.I.P. (IQ–P.I.P.–AP) is shown in Figure 5.11
and an IQ2 P.I.P. (IQ–P.I.P.–SMT or IQ–P.I.P.–DSP) is shown in Figure 5.12.
Fig. 5.12 An Amplifier Sub-block Screen for an IQ2 P.I.P.
Fig. 5.11 An Amplifier Sub-block Screen for a Legacy IQ P.I.P.