Crown Audio IQ-MSD Turbo Software - Manual (Page 175)

IQ–MSD Turbo 1.4 Advanced IQ System Software
Page 175
8.5.2 Simplex Mode Assignments
In simplex mode, a logic input is treated as a stand-alone signal. Each simplex input acts as a simple on/off switch
to interface to the “hardware switches” or controls of the outside world. If all 16 AUX inputs are set to simplex mode,
then up to 16 different controls can be connected to the drone, one to each input. Note: It is also possible to use
analog inputs as simplex AUX inputs. This makes it possible to have a total of 32 AUX controls. This will be
explained later. For example, an on/off switch connected to one input can be used to signal that all amplifiers need
to be turned on or off. A second one can be used to turn on the Auto Level function of an SMX-6. A third one can
be used to make system wide changes to several IQ components, etc.
To assign one or more commands to a simplex AUX input, first use O N to advance to the command Sub-
block screen titled “Simplex Input Commands” as shown in Figure 8.5:
Fig. 8.5 The Drone Simplex Input Commands Sub-block Screen
Each drone command sub-block has four buttons: Add, Modify, Copy and Delete. Use Q R to switch between
the command list on the left and the buttons on the right. To select a button, use Z Y or press A and the first letter
of the button (example, press A+a to select the Add button).
Add: Use the Add button to assign a new command to an input. For example, select Add to assign the amplifier
“Power Ch 1” command (function) to a switch connected to AUX Input 1. Selecting Add summons a window to
prompt you for the assignment information. This is shown in Figure 8.6.
Only one command can be assigned to an input at a time with the command window but you can assign as many
commands as you want to an input by repeating the steps described next and assigning additional commands to
the same input.