Crown Audio IQ-MSD Turbo Software - Manual (Page 90)

IQ–MSD Turbo 1.4 Advanced IQ System Software
Page 90
click on the top edge of each object. This causes them to link to the Container behind them.
When drawing Containers that overlap, an existing Container is usually layered behind the new one, as shown
in Figure 4.25.
It is possible to move a rear Container in front of another Container. First, move the pointer over the rear
Container. Then press
A and click ({) on it to bring it to the front.
Note: To change the attributes of an object after it has been created, click on it with the right mouse button ({).
Fig. 4.25 Normally New Containers Are Layered on Top of Older Containers
Fig. 4.26 Moving a Container to the Front of Another Container
A+{
Move Pointer Over
Desired Container
Older Container
Newer Container