QTECH QSW-2800 Инструкция по настройке - Manual (Page 140)

+7(495) 797-3311 www.qtech.ru
Москва, Новозаводская ул., 18, стр. 1
126
16.7.3 Example of GVRP
GVRP application:
Typical GVRP Application Topology
To enable dynamic VLAN information register and update among switches, GVRP protocol is
to be configured in the switch. Configure GVRP in Switch A, B and C, enable Switch B to learn
VLAN100 dynamically so that two workstations connected to VLAN100 in Switch A and C can
communicate with each other through Switch B without static VLAN100 entries.
Configuration Item Configuration description
VLAN100 Port 2-6 of Switch A and C.
Trunk port Port 11 of Switch A and C, Port 10, 11 of Switch B.
Global GVRP Switch A, B, C.
Port GVRP Port 11 of Switch A and C, Port 10, 11 of Switch B.
Connect two workstations to the VLAN100 ports in switch A and B, connect port 11 of Switch A
to port 10 of Switch B, and port 11 of Switch B to port 11 of Switch C.
The configuration steps are listed below:
Switch A:
Switch(config)# gvrp
PC
PC
Switch A
Switch B
Switch C