QTECH QSW-2800 Инструкция по настройке - Manual (Page 18)

+7(495) 797-3311 www.qtech.ru
Москва, Новозаводская ул., 18, стр. 1
4
The user can now enter commands to manage the switch. For a detailed description for the
commands, please refer to the following chapters.
1.1.2 In-band Management
In-band management refers to the management by login to the switch using Telnet, or using
HTTP, or using SNMP management software to configure the switch. In-band management
enables management of the switch for some devices attached to the switch. In the case when
in-band management fails due to switch configuration changes, out-of-band management can
be used for configuring and managing the switch.
1.1.2.1 Management via Telnet
To manage the switch with Telnet, the following conditions should be met:
Switch has an IPv4/IPv6 address configured;
The host IP address (Telnet client) and the switch’s VLAN interface IPv4/IPv6 address is in the
same network segment;
If 2) is not met, Telnet client can connect to an IPv4/IPv6 address of the switch via other
devices, such as a router.
The switch is a Layer 3 switch that can be configured with several IPv4/IPv6 addresses, the
configuration method refers to the relative chapter. The following example assumes the
shipment status of the switch where only VLAN1 exists in the system.
The foll
owing describes the steps for a Telnet client to connect to the switch’s VLAN1 interface
by Telnet(IPV4 address example):
Manage the switch by Telnet
Step 1: Configure the IP addresses for the switch and start the Telnet Server function on the
switch.
Connected with cable