QTECH QSW-2800 Инструкция по настройке - Manual (Page 34)

+7(495) 797-3311 www.qtech.ru
Москва, Новозаводская ул., 18, стр. 1
20
1. Enable VLAN port mode
Command Explanation
Global Mode
interface vlan <vlan-id>
no interface vlan <vlan-id>
Create VLAN interface (layer 3 interface); the no command
deletes the VLAN interface.
2. Manual configuration
Command Explanation
VLAN Interface Mode
ip address <ip_address> <mask>
[secondary]
no ip address <ip_address>
<mask> [secondary]
Configure IP address of VLAN interface; the no
command deletes IP address of VLAN interface.
ipv6 address <ipv6-address /
prefix-length> [eui-64]
no ipv6 address <ipv6-address /
prefix-length>
Configure IPv6 address, including aggregation global
unicast address, local site address and local link
address. The no command deletes IPv6 address.
3. BOOTP configuration
Command Explanation
VLAN Interface Mode
ip bootp-client enable
no ip bootp-client enable
Enable the switch to be a BootP client and obtain IP
address and gateway address through BootP
negotiation; the no command disables the BootP
client function.
4. DHCP configuration
Command Explanation
VLAN Interface Mode
ip bootp-client enable
no ip bootp-client enable
Enable the switch to be a DHCP client and obtain IP
address and gateway address through DHCP
negotiation; the no command disables the DHCP
client function.