QTECH QSW-2800 Инструкция по настройке - Manual (Page 39)

+7(495) 797-3311 www.qtech.ru
Москва, Новозаводская ул., 18, стр. 1
25
[access {<num-std>|<name>}] [ipv6-access
{<ipv6-num-std>|<ipv6-name>}]
no snmp-server user <user-string> [access
{<num-std>|<name>}] [ipv6-access {<ipv6-num-
std>|<ipv6-name>}]
for SNMP v3.
6. Configure group
Command Explanation
Global Mode
snmp-server group <group-string>
{noauthnopriv|authnopriv|authpriv} [[read <read-
string>] [write <write-string>] [notify <notify-
string>]] [access {<num-std>|<name>}] [ipv6-
access {<ipv6-num-std>|<ipv6-name>}]
no snmp-server group <group-string>
{noauthnopriv|authnopriv|authpriv} [access
{<num-std>|<name>}] [ipv6-access {<ipv6-num-
std>|<ipv6-name>}]
Set the group information on the
switch. This command is used to
configure VACM for SNMP v3.
7. Configure view
Command Explanation
Global Mode
snmp-server view <view-string> <oid-string>
{include|exclude}
no snmp-server view <view-string> [<oid-string>]
Configure view on the switch. This
command is used for SNMP v3.
8. Configuring TRAP
Command Explanation
Global Mode
snmp-server enable traps
no snmp-server enable traps
Enable the switch to send Trap
message. This command is used for
SNMP v1/v2/v3.
snmp-server host { <host-ipv4-address> | <host-
ipv6-address> } {v1 | v2c | {v3 {noauthnopriv |
authnopriv | authpriv}}} <user-string>
no snmp-server host { <host-ipv4-address> |
<host-ipv6-address> } {v1 | v2c | {v3
{noauthnopriv | authnopriv | authpriv}}} <user-
string>
Set the host IPv4/IPv6 address
which is used to receive SNMP Trap
information. For SNMP v1/v2, this
command also configures Trap
community string; for SNMP v3, this
command also configures Trap user
name and securi
ty level. The “no”