QTECH QSW-2800 Инструкция по настройке - Manual (Page 38)

+7(495) 797-3311 www.qtech.ru
Москва, Новозаводская ул., 18, стр. 1
24
Global Mode
snmp-server enabled
no snmp-server enabled
Enable the SNMP Agent function on the switch; the no
command disables the SNMP Agent function on the switch.
2. Configure SNMP community string
Command Explanation
Global Mode
snmp-server community {ro|rw} <string> [access
{<num-std>|<name>}] [ipv6-access {<ipv6-num-
std>|<ipv6-name>}] [read <read-view-name>]
[write <write-view-name>]
no snmp-server community <string> [access
{<num-std>|<name>}] [ipv6-access {<ipv6-num-
std>|<ipv6-name>}]
Configure the community string for
the switch; the no command deletes
the configured community string.
3. Configure IP address of SNMP management station
Command Explanation
Global Mode
snmp-server securityip { <ipv4-address> | <ipv6-
address> }
no snmp-server securityip { <ipv4-address> |
<ipv6-address> }
Configure IPv4/IPv6 security
address which is allowed to access
the switch on the NMS; the no
command deletes the configured
security address.
snmp-server securityip enable
snmp-server securityip disable
Enable or disable secure IP address
check function on the NMS.
4. Configure engine ID
Command Explanation
Global Mode
snmp-server engineid <engine-string>
no snmp-server engineid
Configure the local engine ID on the
switch. This command is used for
SNMP v3.
5. Configure user
Command Explanation
Global Mode
snmp-server user <use-string> <group-string>
[{authPriv | authNoPriv} auth {md5 | sha} <word>]
Add a user to a SNMP group. This
command is used to configure USM