GE Industrial Solutions DV-300 DC Drive Users Manual - Manual (Page 45)

DV-300 Adjustable Speed Drives
——— WIRING PROCEDURES ———
4
1
4 - WirinG ProCedures
4.1 REMOVING ThE FRONT COVER
The front cover of the device must be removed to make the electrical connections and to mount the option card.
W
arning
! Observe the safety instructions and warnings given in this manual. The devices can be opened
without the use of force. Only use the tools specified.
1 2
mounting form 1 mounting form 2, 3 1,5 Nm
1,5 Nm
1
3
3
Figure 4.1.1: Removing the Front Panel
To remove the lower cover of devices, use a phillips screwdriver. Remove the screws, lift cover, and open out
to the front.
Terminal Assignments/Cable Sections
The terminals of the devices are made accessible by removing the front cover.
4.2 WIRING ThE DRIVE
Wire the drive in accordance with the standard connection diagrams, Figures 4.8.1 and 4.8.2.