GE Industrial Solutions DV-300 DC Drive Users Manual - Manual (Page 476)

GEI-100332Ga
——— PARAMETER LISTS ———
10
82
Bitword pad A 519 U16 0 65535 0 R/W
Bitword pad B 536 U16 0 65535 0 R/W
Dig input term 564 U16 0 65535 0 R
Dig output term 581 U16 0 65535 0 R
Load comp [CURR] 698 I16 -2 * TOP_CURR +2 * TOP_CURR - R
Ind store ctrl 912 U16 0 65535 0 R/W
Index storing 913 U16 0 +2 32 -1 - R
Out vlt level 921 U16 0 16384 16384 R/W
F act speed (rpm) [spd] 924 I16 -32768 32767 - R
F act speed (d) [spd] 925 I16 -32768 32767 - R
F T curr % [curr] 928 I16 -2 * TOP_CURR +2 * TOP_CURR - R
Speed ratio 1017 I16 0 32767 +10000 R/W
Spd draw out (d) [SPD] 1018 I16 -32768 32767 - R
T1004
n
ote
! 1) [SPD] = Speed settings are xpressed in RPM * 4
2) [CURR] = Current settings are expressed in European Drive rated current / 2000 [CURR]
= Motor Amps (2000 is TOP_CURR)
3) [ENC_PLS] = Encoders positions are expressed in pulses * 4
4) [ENC_TIM] = Encoders last time (s) are expressed in 50ns units (1=50nS)
5) Encoder 2 parameters (marked with “*” in the table) can be read by the 6KCV300DGF
only if the parameter Speed fbk sel = encoder 2
6) Encoder 1 parameters (marked with “*” in the table) can be read by the 6KCV300DGF
only if
- the parameter Speed fbk sel = encoder 2 and
- a digital encoder is used as encoder 1 (interfacing with the converter by means of
the 6KDV300DES card)
7) Speed reg output [%] contains valid information even if the speed regulator is disabled
(Enable speed reg = Disabled). If Speed reg output is enabled, it contains the sum of actual
speed regulator output and T current ref 2.