GE Industrial Solutions DV-300 DC Drive Users Manual - Manual (Page 78)

GEI-100332Ga
——— CONVERTER OPERATION ———
5
2
5.1.2 Moving inside a menu
- The DRIVE STATUS always appears when the converter is switched on.
- Use the ▲ and ▼ keys to select the individual points within the same menu level.
- Press the ENT key to enter the next menu level.
- Use the CANC key to return to the next higher menu level, irrespective of which menu point was selected.
The appropriate menu of the next higher level will appear once the return has been made.
CANC
ENT
DV-300
DRIVE STATUS
START UP
TUNING
MONITOR
Main menu
ENT
ENT
CANC
CANC
DRIVE STATUS
Ramp ref 1
Menu
Parameter
Enable Drive
CANC
CANC
ENT
3rd level 2nd level
DRIVE STATUS
Start/Stop
CANC
TUNING
CANC
ENT
Speed self tune
CANC
TUNING Speed self tune
Fwd-Rev spd tune
DV-300
DV-300
DV-300 DV-300
Figure 5.1.2.1: Moving inside a menu
5.1.3 Displaying parameters
CANC
ENT
Measurements
Mains voltage
Mains voltage
403 [V]
- Select the parameters within the menu
- Press ENT. The parameter with its relative value will appear.
- Return to the menu using CANC.