Install dbms install sfp modules – Net Optics iBypass HD User Manual

Page 15

Advertising
background image

11

iBypass HD

Install DBMs

If the Dual Bypass Modules (DBMs) are not already installed when you receive the unit, install them by sliding them

into the DBM slots in the front panel. DBMs can be installed in any or all of the four slots; if you do not populate all

of the slots, it does not matter which ones you leave empty. If there is a plate covering the DBM slot, remove it by

unscrewing two thumb-screws; then install the DBM module. The DBM circuit boards slide in the rails provided in the

slots. Push in the DBM firmly until you feel the connectors mate and the bezel is flush with the front panel, but do not

force them. If you encounter resistance, withdraw the module and try again, making sure to align the circuit board in the

rails and slide the module straight in. When the DBM is fully seated, fasten it to the front panel with the two captured

thumbscrews. Unused slots should be protected with blank cover plates.

Slot 1

Slot 2

Slot 3

Slot 4

Figure 7: Installing Dual Bypass Modules (DBMs)

DBMs can be hot-swapped, that is, you can remove and insert DBMs while the iBypass HD is under power and operating.

Tip! ___________________________________________________________________________________________________

You can remove DBMs from the iBypass HD chassis without disconnecting the network cables. Network traffic will

keep flowing because the DBM module itself is a fully passive network Tap. In fiber DBMs, optical switches keep the

network paths open when the DBM is unpowered, even if it is removed from the chassis. In copper DBMs, mechanical

relays keeps the network paths open to traffic.

________________________________________________________________________________________________________

Install SFP Modules

SFP modules are shipped separately. Install them as desired in the SFP slots in the DBMs in the front of the chassis. For

each module, remove the temporary plug from the SFP slot and insert the module until it clicks into place.

Note: __________________________________________________________________________________________________

Net Optics warrants operation with SFP modules sold by Net Optics only.

________________________________________________________________________________________________________

Advertising