Asus RS120-E4/PA2 - Manual (Page 109)

ASUS RS120-E4/PA2 6-3
6.1.2 Installing hard disk drives
The system supports two hot-swap Serial ATA hard disk drives for RAID
configuration.
By default, the SATA hard disk drives are connected to the motherboard SATA1
(Port0) and SATA3 (Port1) connectors via the SATA backplane and SATA cables.
Refer to sections "1.5 Internal components" and "2.4 Hard disk drives" for details
on SATA hard disk drive connection and installation.
For optimal performance, install identical drives of the same model and capacity
when creating a disk array.
6.1.3 Setting the RAID item in BIOS
You must set the RAID item in the BIOS Setup before you can create a RAID set
from SATA hard disk drives attached to the SATA connectors supported by the
Intel ® ICH7R Southbridge chip. To do this:
1. Enter the BIOS Setup during POST.
2. Go to the
Main Menu, select IDE Configuration, then press <Enter>.
3. Set the ATA/IDE Configuration item to [Enhanced Mode], then press
<Enter>.
4. Set the Configure SATA As item to [RAID].
5. Save your changes, then exit the BIOS Setup.
Refer to Chapter 5 for details on entering and navigating through the BIOS
Setup.
6.1.4 RAID configuration utility
Depending on the RAID_SEL1 jumper setting and the operating system, you can
select a utility to create a RAID set. Refer to section 4.2 Jumpers for details on the
RAID_SEL1 jumper settings.
Use the
LSI Logic Embedded SATA RAID Setup Utility to create a RAID 0 and
RAID 1 under Windows ® 2000/2003 Server/XP or Red Hat ® Enterprise ver. 3.0
operating system.
Use the
Intel ® Matrix Storage Manager to create a RAID 0 and RAID 1 under
Windows ® 2000/2003 Server/XP operating system.
Refer to the succeeding sections for details on how to use the RAID configuration
utilities.