Asus RS120-E4/PA2 - Manual (Page 120)

6-14 Chapter 6: RAID configuration
6.2.3 Initializing the logical drives
After creating the RAID set(s), you must initialize the logical drives. You may
initialize the logical drives of a RAID set(s) using the Initialize or Objects
command on the Management Menu.
Using the Initialize command
To initialize the logical drive using the Initialize command:
1. From the Management Menu, highlight Initialize, then press <Enter>.
2. The screen displays the available RAID set(s) and prompts you to select the
logical drive to initialize. Press the <Spacebar> to select the logical drive from
the Logical Drive selection, then press <F10>.