Asus GigaX2024B - Manual (Page 73)

61
GigaX2024B L2 Managed Switch User Manual
5.3.4.1 Interface mode
Use the auto-negotiation configuration command on the switch to set auto-
negotiation status of the port.
CLI Syntax: auto-negotiation
Example: (config)# interface fa1/0/2
(config-if)# auto-negotiation
This example shows how to use the auto-negotiation configuration command on
the switch to enable auto-negotiation mode.
5.3.4.2 Interface duplex
Use the duplex configuration command on the switch to set duplex status of the port.
CLI Syntax: duplex (full| half)
Example: (config)# interface fa1/0/2
(config-if)# duplex full
This example shows how to use the duplex configuration command on the
switch to set full-duplex on the interface.
5.3.4.3 Interface flow control
Use the flow control configuration command on the switch to set flow control
status of the port.
CLI Syntax: flowcontrol (rx| tx | both)
Example: (config)# interface fa1/0/2
(config-if)# flowcontrol both
This example shows how to use the flow control configuration command on the
switch to set flow control both on.
5.3.4.4 Show L2 interface
Use the show interface command on the switch to show interface status.
CLI Syntax: show interfaces IFNAME
Example: ASUS# show interface fa1/0/2