Asus GigaX2024B - Manual (Page 78)

66
GigaX2024B L2 Managed Switch User Manual
5.3.10.2 no mac-address-table multicast
Use the no mac-address-table multicast configuration command on the switch
to remove multicast static port to the MAC address table.
CLI Syntax: no mac-address-table multicast MACADDR VLANID IFLIST
Example: (config)# no mac-address-table multicast 0100.5e11.1111 2
fa1/0/1-3
5.3.10.3 show mac-address-table multicast
Use the show mac-address-table multicast user EXEC command to display the
Layer 2 multicast entries for all VLANs. Use the command in privileged EXEC
mode to display specific multicast entries.
CLI Syntax: show mac-address-table multicast
Example: ASUS# show mac-address-table multicast
5.3.11 IGMP snooping
5.3.11.1 ip igmp snooping
This command sets the IGMP snooping function enabled globally.
CLI Syntax: ip igmp snooping
Example: (config)# ip igmp snooping
5.3.11.2 interval time
This command sets the interval time for the IGMP queries sent by switch.
CLI Syntax: ip igmp snooping last-member-query-interval TIMEVALUE
Example: (config)# ip igmp snooping last-member-query-interval 100
5.3.12 Traffic control
5.3.12.1 storm-control
Use the storm-control configuration command on the switch to set the limit rate
of the portʼs total bandwidth used by broadcast/dlf/multicast.
CLI Syntax: storm-control (broadcast|dlf|multicast) LIMIT_RATE
Example: (config)# storm-control broadcast 25