Asus GigaX2024B - Manual (Page 94)

82
GigaX2024B L2 Managed Switch User Manual
Figure 65. Detaching the fan from the module
5. Fasten the new fan with the screws that you removed earlier. Make sure that
the fan cable is near the bottom of the module.
Follow the same steps to replace the other fan.
6. Connect the fan cables to the PCB. Make sure that the fan cables are
connected to the correct fan connector. FAN 1 is on the left side when you
are facing the rear panel.
7. Insert the fan module to the switch chassis until it fits in place. Make sure that
the fan power cables are not caught between the fan module and chassis.
8. Secure the fan module to the chassis with the thumbscrew. Check around
the fan module to make sure no cable is caught between the chassis and
the fan module.
Fan specifications
Dimensions: 40 x 40 x 20 mm
Voltage and Current: 12VDC, 0.13A
Speed: 8200RPM
3. Carefully pull the two power cables from the fan connectors.
4. Loosen the screws that secure the fan to the module. Remove the defective fan.