Asus GigaX2024B - Manual (Page 41)

29
GigaX2024B L2 Managed Switch User Manual
4.5.7 Traffic control
Traffic control prevents the switch bandwidth from flooding packets including
broadcast packets, multicast packets and the unicast packets because of destination
address lookup failure. The limit number is a threshold to limit the total number of the
checked type packets. For example, if broadcast and multicast are enabled, the total
traffic amount for those two types will not exceed the limit value.
Selects an interface and assigns desirable settings, then click
Modify.
Click OK to save the new configuration. To make the configuration effective, go to
“Save Configuration” page, then click Reload.
Figure 28. Traffic Control
4.5.8 Dynamic addresses
This page displays the result of dynamic MAC address lookup by port, VLAN ID, or
specified MAC address. The dynamic address is the MAC address learned by switch,
it will age out from the address table if the address is not learned again during the
age time. User can set the age time by entering a valid number from 10 to 1,000,000
in seconds. Then click on OK to save the new age value. To make the configuration
effective, please go to “Save Configuration” page, then click on Reload.
You can look up MAC addresses by checking the port, VLAN ID, or/and MAC address,
then click on the Query. The address window will display the result of the query.
Figure 30. Dynamic Address