Asus GigaX2024B - Manual (Page 88)

76
GigaX2024B L2 Managed Switch User Manual
Note
6 IP Addresses, network masks, and
subnets
6.1 IP addresses
This section pertains only to IP addresses for IPv4 (version 4 of
the Internet Protocol). IPv6 addresses are not covered.
This section assumes basic knowledge of binary numbers, bits, and bytes. For
details on this subject, see Chapter 8.
IP addresses, the Internetʼs version of telephone numbers, are used to identify
individual nodes (computers or devices) on the Internet. Every IP address
contains four numbers, each from 0 to 255 and separated by dots (periods), e.g.
20.56.0.211. These numbers are called, from left to right, field1, field2, field3,
and field4.
This style of writing IP addresses as decimal numbers separated by dots is
called dotted decimal notation. The IP address 20.56.0.211 reads “twenty dot
fifty-six dot zero dot two-eleven.”
6.1.1 Structure of an IP address
IP addresses have a hierarchical design similar to that of telephone numbers.
For example, a 7-digit telephone number starts with a 3-digit prefix that identifies
a group of thousands of telephone lines, and ends with four digits that identify
one specific line in that group.
Similarly, IP addresses contain two kinds of information.
Network ID
Identifies a particular network within the Internet or intranet
Host ID
Identifies a particular computer or device on the network
The first part of every IP address contains the network ID, and the rest of the
address contains the host ID. The length of the network ID depends on the network
class (see following section). Table 7 shows the structure of an IP address.
Table 8. IP address structure
Field1 Field2 Field3 Field4
Class A Network ID Host ID
Class B Network ID Host ID
Class C Network ID Host ID