Asus GigaX2024B - Manual (Page 76)

64
GigaX2024B L2 Managed Switch User Manual
5.3.7.2 trunk load balancing
Use the aggregation-link trunk group configuration command on the switch to
configure trunk load balancing by using source-based or destination-based
forwarding methods.
CLI Syntax: aggregation-link group <1-6> load-balance (src-mac |dst-mac
|src-dst-mac |src-ip |dst-ip |src-dst-ip)
Example: ASUS#aggregation-link group 1 load-balance src-mac
5.3.7.3 show aggregation-link trunk
To show aggregation-link trunk status.
CLI Syntax: show aggregation-link group [GROUPID]
Example: ASUS# show aggregation-link group 1
5.3.8 LACP
5.3.8.1 lacp aggregation-link trunk
This command sets the Link Aggregation Control Protocol (LACP) operation
add/set for the trunk group ports on the switch.
CLI Syntax: lacp aggregation-link group <1-6> (add|set) IFLIST
Example: ASUS# lacp aggregation-link group1 add fa1/0/1-3
5.3.8.2 disable lacp aggregation-link trunk
This command sets the Link Aggregation Control Protocol (LACP) operation
add/set or disable for the trunk group ports on the switch.
CLI Syntax: no lacp aggregation-link group <1-6>
Example: ASUS# no lacp aggregation-link group 1
5.3.8.3 lacp system-priority
This command sets the system priority for the Link Aggregation Control Protocol
(LACP) on the switch.
CLI Syntax: lacp system-priority <1-65535>
Example: (config)# lacp system-priority 20000