Asus KFN5-D SLI - Manual (Page 121)

ASUS KFN5-D SLI 5-11
5.3 Silicon Image RAID configurations
The Silicon Image Sil3132 RAID controller supports RAID 0 and RAID 1
configurations. Use the Silicon Image RAID utility to configure a disk array.
5.3.1 Setting the BIOS RAID items
After installing the hard disk drives, make sure to set the necessary RAID
items in the BIOS before setting your RAID configuration.
To set the BIOS RAID items:
1. Boot the system and press <Del> during the Power-On Self-Test
(POST) to enter the BIOS Setup Utility.
2. From the Advanced > Onboard Devices Configuration menu item in the
BIOS set the Onboard Sil3132 SATALink item to RAID Mode and set
the Onboard Serial-ATA BOOTROM item to Enabled. See section “4.4.5
Onboard Devices Configuration” for details.
3. Save your changes and Exit Setup.
Launching the Silicon Image Array Management Software
Launch the Silicon Image Array Management software from Windows ® XP by
clicking the Start button and selecting All Programs > Silicon Image > Sam
For details on the Silicon Image SATARaid™ RAID configuration, refer to
the “Sil3132 User’s Manual” in your motherboard support CD:
\Drivers\Sil3132\Raid\SATARAID5-UserGuide_v1.40.pdf