Asus KFN5-D SLI - Manual (Page 88)

4-22 Chapter 4: BIOS setup
Memclock Value [200 MHz]
Sets the memory clock mode limit.
Configuration options: [200 MHz] [266 MHz] [333 MHz]
MCT Timing Mode [Auto]
Sets the MCT Timing Mode. Configuration options: [Auto] [Limit]
Bank Interleaving [Auto]
Allows you to enable the bank memory interleaving.
Configuration options: [Disabled] [Auto]
Enable Clock to All DIMMs [Disabled]
Configuration options: [Disabled] [Enabled]
DQS Signal Training Control [Enabled]
Enables or disables the DQS Signal Timing Training control.
Configuration options: [Disabled] [Enabled]
MemClk Tristate C3/ALTVID [Disabled]
Configuration options: [Disabled] [Enabled]
CS Sparing Enable [Disabled]
Configuration options: [Disabled] [Enabled]
Memoryy Hole Remapping [Enabled]
Enables or disables the memory remapping around memory hole.
Configuration options: [Disabled] [Enabled]
Memclock Mode [Auto]
Sets the memory clock mode.
Configuration options: [Auto] [Limit] [Manual]
The following item appears when the Memclock Mode is set to Limit or
Manual.