Asus KFN5-D SLI User Manual
Page 46
![background image](/manuals/301859/46/background.png)
2-26
Chapter 2: Hardware information
2. Primary IDE connector (40-1 pin PRI_IDE1)
The onboard IDE connector is for Ultra DMA 133/100/66 signal
cable. There are three connectors on each Ultra DMA 133/100/66
signal cable: blue, black, and gray. Connect the blue connector to
the motherboard’s IDE connector, then select one of the following
modes to configure your device(s).
• Pin 20 on the IDE connector is removed to match the covered hole
on the Ultra DMA cable connector. This prevents incorrect insertion
when you connect the IDE cable.
• Use the 80-conductor IDE cable for Ultra DMA 133/100/66 IDE
devices.
If any device jumper is set as “Cable-Select,” make sure another device
jumper has the same setting.
Drive jumper
setting
Mode Cable of
device(s)
Cable connector
Single device
Cable-Select or
Master
-
Black
Two devices
Cable-Select
Master
Slave
Black
Gray
Master
Slave
/
Black or gray
KFNS-D-SLI
R
KFN5-D SLI IDE Connector
PRI_IDE