Asus Adaptec 2025 ZCR - Manual (Page 114)

D-9
Command Line Interface
Enabling Automatic Failover
To enable automatic failover, use the controller set
automatic_failover command with the /failover switch, as in
the following example:
AAC0> controller set automatic_failover
/failover_enabled=TRUE
Executing: controller set automatic_failover
/failover_enabled=TRUE
After running the controller set automatic_failover command,
use the controller show automatic_failover command to verify
that automatic failover has been enabled. If necessary, you can now
replace a failed disk with a replacement disk.
Displaying Controller Information
Controllers exhibit a number of attributes that you can display or
manage using the following CLI commands:
■ Controller List
■ Controller Details
Controller List
The controller list attributes are defined as follows:
■ Adapter Name —Name
■ Adapter Type —Product name
■ Controller Availability —Access mode
Example
Before opening a controller, you may want to use the controller
list command to display all controllers. In the following example,
the Adapter Name column indicates that AAC0 is the name of the
controller installed on the computer. The example also indicates the
controller’s path (
\\.\ ).
CLI> controller list
Executing: controller list
Adapter Name
Adapter Type Availability
------------ ------------ ------------
\\.\AAC0 Adaptec xxxxx read/write