Asus Adaptec 2025 ZCR - Manual (Page 86)

B-6
ACU for DOS
Array Definition Block Keywords
The array definition block always begins with the keyword Array
and ends with the keyword End . The other required array definition
keywords are Drives and Type . The array definition keywords
are listed in the table below alphabetically.
Keyword Required?
Default
Value Description
Array Yes None Indicates the start of an array
definition block. See
page B-7 ).
Drives Yes None Specifies the devices used in
creating the array. See
page B-7 ).
End Yes None Indicates the end of an array
definition block. See
page B-7
for details.
HotspareDrives No None Specifies the hotspares to
assign to the array. See
page B-8 ).
InitializeAll No No Indicates whether to initialize
all the drives connected to the
controller. See
page B-8 ).
Method Yes Build Indicates the method (Build/
Verify, Clear, or Quick Init) to
use when creating a redundant
array (see
page B-9 .
ReadCache No Yes Indicates whether read
caching is enabled for this
array (see
page B-10 ).
Size No Maximum Specifies the size of the array
(see
page B-10 ).
StripeSize No 64 Specifies the size of contiguous
I/O, in bytes (see
page B-10 ).
Type Yes None Indicates the type of array to
create (see
page B-9 ).
Wait No Yes Indicates whether the ACU
should wait for the new array’s
build/verify or clear to com-
plete before continuing (see
page B-11 ).
WriteCache No Yes Indicates whether write cach-
ing is enabled for this array
(see
page B-11 ).