Asus Adaptec 2025 ZCR - Manual (Page 46)

3-9
Installing the Driver
3 Turn on the computer, then insert the driver disk.
4 To run the pkgadd utility, type pkgadd -d diskette1 and then
press Enter. UNIX reads the disk and package information.
5 Press Enter.
6 Restart the computer. The system rebuilds the kernel
automatically.
7 Add devices created on the RAID controller to the operating
system. For details, refer to your OpenServer documentation.
Installing the NetWare Driver
This section contains the following procedures:
■ Installing the Driver When You Install NetWare on page 3-9
■ Installing the Driver in an Existing NetWare System on page 3-10
■ Loading NetWare Drivers During Server Restart on page 3-11
Installing the Driver When You Install NetWare
To install the driver with the operating system during a fresh
install:
1 Install and configure the controller and hard drives, as
described in
page 2-3 .
2 Create the bootable array, as described on page 2-5 .
3 Create the driver disk, as described on page 3-2 . When finished,
remove the driver disk.
4 Restart the computer, then press Ctrl+A when prompted to access
the ARC utility. Use ARC to create the RAID. For details, see
Using the Adaptec RAID Configuration (ARC) Utility on page 2-6 .
5 Install and configure a secondary controller, if any.
6 Create the driver disk, as described on page 3-2 . When finished,
remove the driver disk.
7 Install the operating system according to the NetWare
documentation. Verify that you have the
aacraid.ham and
aacraid.ddi files available on the driver disk created at the
beginning of this chapter.