Asus Adaptec 2025 ZCR - Manual (Page 45)

3-8
Installing the Driver
UnixWare and OpenUNIX
This section contains the following procedures:
■ Installing the Driver When You Install UnixWare or OpenUNIX
■ Installing the Driver in an Existing UnixWare or OpenUNIX System
Note: Although the driver disk you create for UnixWare and
OpenUNIX differ, the installation procedures for these
operating systems are the same.
Installing the Driver When You Install UnixWare or OpenUNIX
To install the driver with the operating system during a fresh
install:
1 Install and configure the controller and hard drives, as
described in
page 2-3 .
2 Create the bootable array, as described on page 2-5 .
3 Create the driver disk, as described on page 3-2 . When finished,
remove the driver disk.
4 Insert the Unix installation CD and start the operating system
installation.
5 When you see the prompt, Choose One , insert the driver disk,
select Install HBA diskette, and then press F10.
The computer loads the driver from the driver disk, then the
HBA screen is displayed.
6 Select Proceed with Installation, then press F10.
7 Complete the installation as appropriate.
8 When the installation is finished, remove the driver disk and
restart the computer.
Installing the Driver in an Existing UnixWare or OpenUNIX System
To install the driver in an existing operating system:
1 Shut down the computer. Install and configure the controller
and hard drives, as described in
Chapter 2 .
2 Create the driver disk, as described on page 3-2 . When finished,
remove the driver disk.