YSI NiCaVis 701 IQ NI - Manual (Page 20)

Commissioning
NiCaVis 70x IQ NI
3 - 10 ba76132e01 03/2013
Measuring location NiCaVis 701 IQ NI :
 Activation
 Inlet

Outlet
NiCaVis 705 IQ NI :

Outlet
(permanently set)
Measurement location or application of
the sensor.

The possible measurement loca-
tions are displayed depending on the
currently set measuring mode.
 The sample matrix on which the cal-
culation of the measured value is
based changes with the location of
the sensor.
When the measurement location is
changed, all virtual sensors are
deleted.
Measuring range - Display of the measuring range
(see chapter 8 T ECHNICAL DATA ).
Cal - # raw value 1 Value pairs of the user calibration (see section 4.3.2).
Note: Leave those values unchanged during the initial commission-
ing.
Cal - ref. value 1
Cal - # raw value 2
Cal - ref. value 2
Number of N-sensors
Number of C-sensors
1 ... 2
0 ... 3
Apart from the main sensor, up to 4
more sensors can be displayed.
The settings for the additional sensors
are done in the menus for the respec-
tive sensors.
Zero adjustment Factory
User
Setting of which zero adjustment is
used in the sensor.

Factory zero adjustment or
 Zero adjustment carried out last
Signal smoothing  On
 Off
Switching on/off the signal smoothing.
For more details, see Response time
t90 .
Menu item Settings Explanations