Xylem MultiLab 4010-2 - Manual (Page 66)

Settings MultiLab 4010-2
66 ba76142e01 05/2013
9.3 D.O. measurement settings
9.3.1 Settings for D.O. measurement
The settings are available in the menu for measurement and calibration set-
tings. To open the settings, display the required measured parameter in the
measured value display and press the <ENTER> key. After completing the set-
tings, switch to the measured value display with <M>.
Menu item Possible
setting Explanation
Calibration /Calibra-
tion record - Displays the calibration record of the
last calibration.
Calibration / Cali-
bration data storage
/ Display - Displays the last calibration records
(max. 10)
Calibration / Cali-
bration data storage
/ Output to USB
flash drive or printer - Outputs the stored calibration data to
the USB-A interface (USB memory
device/USB printer)
Calibration / Cali-
bration data storage
/ Output to RS232/
USB - Outputs the stored calibration data to
the USB-B interface (PC)
Calibration /
Calibration data
storage / Number of
cal. points 1
2 1-point calibration
or
2-point calibration
Calibration /Calibra-
tion interval 1 ... 180 ...
999 d Calibration interval for the D.O. sensor
(in days).
The meter reminds you to calibrate
regularly by the flashing sensor symbol
in the measuring screen.
Calibration /Com-
parison meas. on
off Enables to adjust the measured value
with the aid of a comparison measure-
ment, e.g. Winkler titration.
For details, see section 7.2 C
ALIBRA -
TION , page 48.
Sal automatic on
off Automatic salt content correction for
concentration measurements. The
measured salinity value is taken over
by a connected conductivity sensor.
This menu item is only available if an
IDS conductivity sensor is connected.
Sal correction on
off Manual salt content correction for con-
centration measurements.