Front panel configuration port, Front panel configuration port -3 – Extron Electronics Fiber Matrix 6400 User Manual
Page 67
4-3
Fiber Matrix 6400 Switcher • Programmer’s Guide
Front panel Configuration port
N
This port is hardwired for RS-232 only.
N
This port is independent of the rear panel Remote port and is not affected by
changes to the rear panel port’s protocol. This front panel port’s protocol can
be changed via an SIS command only. See the Command/Response table for
IP-Specific SIS commands, later in this chapter, to configure both ports using an
SIS command.
The optional 9-pin D to 2.5 mm mini jack TRS RS-232 cable, part #70-335-01 can be
used for connection to the Configuration port.
6 feet
(1.8 m)
Part #
70-335-01
5
1
9
6
Sleeve (Gnd)
Ring
Tip
9-pin D
Connection
TRS Plug
Pin 2
Computer's RX line
Tip
Pin 3
Computer's TX line
Ring
Pin 5
Computer's signal ground
Sleeve
Optional 9-pin TRS RS-232 cable