Extron Electronics IPL 250 Reference Manual - Manual (Page 106)

Index, cont’d
IPL 250 • Index C-4
PRELIMINAR
Y
modes
DHCP mode and SIS commands 4-15
IR playback mode variable in SIS commands 4-11
reset 2-10
reset mode SIS commands 4-23
serial communication standard
SIS commands 4-9
serial pass-through mode
SIS commands for 4-10
verbose 4-16
momentary
relay wiring and function 2-9
mounting
furniture 2-5
projector pole 2-5
rack 2-4
UL rack mounting guidelines 2-4
mounting accessories
part numbers and names A-4
P
part numbers A-4
cables A-5
SIS command for 4-13
pass-through
serial pass-through (redirect mode) 3-13
SIS commands for 4-10
passwords
IPL’s responses 4-2
prompts from the IPL 4-2
requirements for 3-21, 4-6
SIS commands for 4-16
Passwords embedded Web page 3-21
ping
using the ping command in troubleshooting 3-29
using the ping command with the arp command in IP
setup 3-4
Port Settings
embedded Web page 3-20
power connector
wiring, polarity, requirements 2-6
projector pole mounting 2-5
Q
query strings 5-5
R
rack mounting 2-4
UL rack mounting guidelines 2-4
redirect mode
serial pass-through (redirect mode) 3-13
relay
momentary contact
relay wiring and function 2-9
relay ports
SIS commands 4-12
wiring 2-9
remapping ports
SIS commands for 4-17
Reset button
Reset button and LED location 2-3
using to reset the unit 2-10
reset modes
reset modes table 2-10
reset (zap) commands and erase commands (SIS) 4-22
resetting the unit
manual reset modes 2-10
reset (zap) commands and erase commands (SIS) 4-22
Reset Device After Firmware Update B-7
RS-232 protocol
COM port defaults 2-7
S
s19 file type A-7
serial bridging 3-15
hardware connection (cabling) 3-15
serial bridge configuration 3-15
serial pass-through mode
SIS command to configure 4-10
serial pass-through (redirect mode) 3-13
serial ports
advanced control methods 3-13
direct port access (ports 2001 through 2003 3-14
serial bridging 3-15
serial pass-through (redirect mode) 3-13
Server Side Include (SSI)
command syntax 5-3
host commands 5-3, 5-5
host vs. remote commands 5-3
remote commands 5-3, 5-5
SIS programming and control 4-1
SSI.
See Server Side Include (SSI)
straight-through cable
connector wiring and when to use 2-7
subnet
SIS commands for setting and reading 4-15
system requirements 1-5
System Settings (GlobalViewer Web page) 3-19
T
TouchLink touchpanel
as part of a system with an IPL 250 1-2
overview about using with an IPL 250 1-5
setting up the panel and configuring the IPL to work with
it 3-27
touchpanel
as part of a system with an IPL 250 1-2
troubleshooting 3-29