Extron Electronics IPL 250 Reference Manual - Manual (Page 88)

IPL 250 • Reference Material A-2
Reference Material
Specifications
Connectors ..................................... 1 RJ-45 female connector
Data rate ......................................... 10/100Base-T, half/full duplex with autodetect
Protocols ......................................... ARP, ICMP (ping), IP, TCP, UDP (port 3121, audio), DHCP, HTTP, SMTP,
Telnet
Default settings .............................. Link speed and duplex level = autodetected
IP address = 192.168.254.254
Subnet mask = 255.255.0.0
Gateway = 0.0.0.0
DHCP = off
Web server ...................................... Up to 200 simultaneous sessions
7.25 MB nonvolatile user memory
Program control ............................. Extron Global Configurator 3 for Windows ®
Extron Simple Instruction Set (SIS ™ )
Microsoft ® Internet Explorer ® , Telnet
Global Viewer requirements ........ Microsoft ® Internet Explorer ver. 6 or higher
Serial control interface
Quantity/type ............................... 3 bidirectional RS-232
Connectors ..................................... (1) 3.5 mm captive screw connector, 5 pole
(2) 3.5 mm captive screw connectors, 3 pole
Baud rate and protocol ................. 300 to 115200 baud
Default settings (adjustable): 9600 baud, 8 data bits, 1 stop bit, no parity
N The 5-pole port supports both hardware and software flow control.
The 3-pole ports support software flow control.
Pin configurations
Serial, 5-pole captive screw Pin 1 = TX, 2 = RX, 3 = GND, 4 = RTS, 5 = CTS
Serial, 3-pole captive screw Pin 1 = TX, 2 = RX, 3 = GND
IR control interface
Quantity/type ............................... 4 IR (carrier and non-carrier)
Connectors ..................................... (2) 3.5 mm captive screw connectors, 4 pole
IR output carrier frequency ......... 30 kHz to 1 MHz
Pin configurations ......................... Pins 1, 3, 5, 7 = IR signal ports 1, 2, 3, 4 (respectively)
Pins 2, 4, 6, 8 = GND
IR learning carrier frequency ....... 30 kHz to 1 MHz
IR learning capture distance ........ 2" (5.1 cm) to 12" (30.5 cm) from the front panel
Relay control interface
Quantity/type ............................... 4 normally open relays
Relay control connectors .............. (2) 3.5 mm captive screw connectors, 4 pole
Relay control contact rating ......... 24 V, 1 A
Contact closure control interface
Quantity/type ............................... 4 contact closure inputs
Contact input control connector . (1) 3.5 mm captive screw connector, 5 pole
Contact closure (input only)
Input voltage range ........... 0 to 5 VDC, clamped at +5.1 V
Input impedance ............... 10k ohms
Threshold............................ 1.6 VDC
Pin configuration ........................... Pins 1, 2, 3, 4 = inputs 1, 2, 3, 4; pin 5 = GND