Error messages – Extron Electronics VN-Matrix 250 User Guide User Manual
Page 132
]
— Carriage return with line feed (Hex:
0D0A
)
}
— Carriage return without line feed (Hex:
0D
)
This character can be used interchangeably with the pipe character (
|
)
•
— Space character (Hex:
20
)
E
— Escape key (Hex:
1B
)
This character can be used interchangeably with the upper‑case
W
character.
The
X/
values defined in this section are the variables used in the fields of the command
and response table (see page 127).
X%
—
Status
0 = disabled, off, or undetected
1 = enabled, on, or detected
X^
— Port number (default =
5432
)
X1$
—
IP or Gateway address, in decimal format: four octets separated by periods.
For example 192.168.253.254 (default value for LAN 1)
or 192.168.254.254 (default value for LAN 2)
Leading zeros in any of the four fields are optional in setting values and are suppressed
in returned values.
X1*
—
Hardware (MAC) address
X1(
—
Subnet mask in decimal format: four octets separated by periods.
for example 255.255.0.0
.
The default value is 255.255.255.0.
Leading zeros in any of the four fields are optional in setting values and are suppressed
in returned values.
The subnet value is returned in standard format (255.255.255.0), not /24.
X57^
—
NIC (Network Interface Card) Address for LAN 1 or LAN 2.
Error Messages
E10
— Invalid command
E13
— Invalid value (too large)
E14
— Invalid command for this configuration
VNM 250 • SIS Commands
126