Configuring encoder video – Extron Electronics VN-Matrix 250 User Guide User Manual
Page 73
Configuring Encoder Video
9.
In the
Configuration
panel, click on
VideoPort0
(see figure 47,
1
):
1
1
Figure 47.
Device Configuration Panel
The
Configure
tab opens with video options.
1
1
1
2
2
3
3
4
4
5
5
Figure 48.
Configure Tab (Video Options)
10.
Ensure the
Input
Channel
is set to
auto
(see figure 48,
1
).
11.
Set the
EDID
(D)
for the digital video input and the
EDID
(A)
for the analog input, as
required (see figure 48,
2
).
12.
If a digital source with HDCP is connected, ensure that the
HDCP
Authorize
box is
selected (see figure 48,
3
).
13.
Ensure the
Current
Mode
shows the format of the connected source (see
figure 48,
4
).
14.
If
RTP multicast source streaming is
required, select the
Multicast
Enable
box
(see figure 48,
5
). A dialog is displayed
asking for a multicast address (see the
figure to the right). This must be obtained
from your network administrator.
If
RTP unicast is required, ensure the
Multicast
Enable
box is deselected.
VNM 250 • Configuration with the VNM 250 GUI
67