Configuring encoder data – Extron Electronics VN-Matrix 250 User Guide User Manual
Page 77
Configuring Encoder Data
1.
Click on the
Device
tab.
2.
In the
Configuration
panel, click on
data
(see figure 54,
1
):
1
1
Figure 54.
Device Configuration Panel
The
Configure
tab opens with data options.
1
1
2
2
3
3
4
4
Figure 55.
Configure Tab (Data Options)
3.
If required, check the
Serial Enable
box (see figure 55,
1
).
4.
If required, check the
UDP Enable
box (see figure 55,
2
).
5.
If required, enter a value for the
UDP port
number (see figure 55,
3
).
6.
If
RTP multicast source streaming is required, select the
Multicast Enable
box (see
figure 5,
4
). If
RTP unicast is required, ensure the box is deselected.
ATTENTION: Use the same transport type for all streams. Check that the
Multicast
Enable
setting on the data tab is the same as that on the video (see
on page 67).
7.
Click the
Save All
tab.
8.
Encoder setup is now complete. Repeat this procedure for each encoder in the system.
VNM 250 • Configuration with the VNM 250 GUI
71