Configuring the decoder audio – Extron Electronics VN-Matrix 250 User Guide User Manual
Page 81
Configuring the Decoder Audio
1
1
2
2
Figure 61.
Decoder Audio Bandwidth Link
1.
In the
Display
tab, ensure that the
Audio
check box (see figure 61,
1
) is selected.
2.
Click the bandwidth
audio
link (see figure 61,
2
). The
Bandwidth
(audio) tab opens.
This is the same as the
Bandwidth
(video) tab but has an
Audio
Control
panel (see
figure 62):
1
1
2
2
3
3
Figure 62.
Bandwidth (audio) Tab
3.
Select the appropriate check boxes to output the received audio stream to the
HDMI
port, the
Analog
output port or both (see figure 62,
1
).
4.
The analog audio output level is controlled using
Analog Output Level
(see
figure 62,
2
). The output level is correct if the input level on the encoder was correctly
configured for optimum signal.
5.
Select the input level for the reverse audio, using
Analog Input Level
(see
figure 62,
3
).
Set the value just larger than the maximum value that will be input. (For
more information about the Bandwidth (audio) tab, see
6.
Save the changes by clicking
Save All
.
NOTE:
•
The active status information on this page updates only if the
audio
check
box is selected in step 1, above.
•
If the check box was not selected, no audio signal is carried by the selected
stream and there will be no audio output by the VND 250, even if the
HDMI
or
Analog
Audio boxes are selected.
VNM 250 • Configuration with the VNM 250 GUI
75