Extron Electronics VN-Matrix 250 User Guide User Manual

Page 134

Advertising
background image

Command

ASCII Command
(host to unit)

Response
(unit to host)

Additional Description

General
Query Firmware
version

Q

x.xx.xxx

]

Firmware version as

x.xx.xxx

(major.minor.build)

Query Part
Number

N

Pno xx-xxxx-xx

]

Part number

60-1274-01

(encoder)

60-1275-01

(decoder)

Query Model
Name

I

VNE

•

250

•

Matrix

]

or

VNE

•

250

•

Matrix

]

Model name

VNE

•

250

•

Matrix

(encoder)
VND

•

250

•

Matrix

(decoder)

Absolute System
Reset

E

ZQQQ

}

Zpq

]

Runs the

sanitize

feature (see

page 99) of the VNM 250

Reboot System

E

1BOOT

}

Boot1

]

Saves and commits any
changes made to the network
settings

Restart Network

E

2BOOT

}

Boot2

]

Works in the same way
as Boot 1. Currently, the
VNM 250 does not support a
restart of network ports alone.

NOTES:

•

Trying to set an IP address, subnet mask, or gateway address while DHCP is enabled, will result in an E14
(Invalid command for this configuration) error message.

•

Using the CISG command (to set the IP address, subnet mask, and gateway address at the same time)
while DHCP is enabled, disables DHCP.

•

Any changes to the network settings require a reboot to enforce them.

•

Currently, SIS implementation by the VNM 250 supports only Extron Verbose mode 0.

•

To comply with industry standards, there cannot be any "1" bits to the right of a "0" bit in a subnet mask.
For example, 255.255.128.0 (11111111.11111111.

10000000.00000000) is valid;

255.255.64.0 (11111111.11111111.

01000000.00000000) returns an E13 (Invalid value) error message.

VNM 250 • SIS Commands

128

Advertising