Elmo Rietschle L-BV7 - Manual (Page 21)

© Gardner Denver Deutschland GmbH 21 / 64 610.48060.40.000
Transport and Handling
Transport and handling by means of a crane
and strap belts is advisable.
Fig. 4: Attachment points
Attach the strap belts as shown in Fig. 4,
Pg. 21:
 Use two strap belts, of which one is routed
under the vacuum pump/compressor
housing, and one under the fan guard.
 The strap belts should be seated securely
in the undercuts so that the unit cannot slip
out.
 The belts must be sufficiently long (spread
angle smaller than 90°).
 Make sure that no damage is caused to any
attached fittings.
 WARNING
Danger from tipping loads!
Be sure to observe the routing of
the strap belts as shown in
Fig. 4, S. 21, even if the motor is
provided with attachment points
such as transport eyes or eye
bolts.
These are solely designed for the
separate transport of the motor,
however not for the different
weight distribution that results for
the mounted vacuum
pump/mounted compressor, so
that the unit could tip!