ABUS TVCC75200 - Manual (Page 60)

60
5. Quick Guide Control Devices
Basically you can control High Speed Motor Domes with all RS485 devices that can handle Pelco P
or Pelco D protocol.
Please refer to respective instruction manual for the connection method and further information.
5.1 Control using Operator Panel TV7605
See all information about the connection method and other information in instruction manual of
TV7606. This operator panel is designed specially for TV7600-TV7604 and supports all functions.
5.2 Control using TV3000-TV3031 recorders
You can also control your high-speed motor dome with the HDVR.
This requires the following actions.
1. Connect the RS-485 lines to the interface for controlling on the HDVR.
2. Link up the analogue camera to the software. Refer to the operating manual for more
details.
3. Activate the Pan/Tilt control.
4. Select ABUS Security-Center as the protocol type.
5. Enter the ID for the camera.
6. Select COM 3 as the port interface.
7. Settings for the interface: Enter the baud rate used by your camera.
The remaining settings do not need to be changed.
8. Click on Save and Apply to accept the changes.
You can then control the high-speed motor dome with the VMS software.
To go to the configuration menu of your camera, right-click with the mouse on the preview image.
Now select the Pan/Tilt configuration menu item.
You are in the configuration menu of the camera and can navigate in the menu using the arrow
keys.