ABUS TVCC75200 - Manual (Page 73)

73
8.5 Auto Scan Set
66 + preset (Maxpro: 86+Preset) button starts AUTO SCAN after setting.
1. AUTO SCAN – START ANGLE
To set start angle, press FOCUS FAR button and move joystick to the starting angle which is
needed to be memorized. Press FOCUS FAR button again to escape.
2. AUTO SCAN – END ANGLE
To set end angle, press FOCUS FAR button and move joystick to the starting angle which is
needed to be memorized. Press FOCUS FAR button again is escape.
3. AUTO SCAN – DIRECTION
Auto scan direction of rotation can be set clockwise or counterclockwise.
CW: Clockwise direction (Default)
CCW: Counterclockwise direction
4. AUTO SCAN – ENDLESS
Auto Scan rotation can be set endless. Move joystick rightwards in order to select ON. The
default setting is OFF.
5. AUTO SCAN – SPEED
Auto scan speed can be adjusted from 05° per second up to 35° per second.
The default setting is 10°/S.
6. AUTO SCAN – DWELL TIME
This menu item is the delay time when an angle is arrived and the dome starts to drive back
to another angle.
This menu item does not affect when endless is adjusted.
Move joystick to the left or right in order to adjust dwell time. Dwell time can be adjust from
01 second to 99 seconds and the default setting is 03 seconds.
7. AUTO SCAN – SAVE AND EXIT
To save the changed data and return to the main menu, move the joystick to the right with
the cursor on SAVE AND EXIT.
AUTO SCAN SET
START ANGLE : XXX.X.XX.X
END ANGLE : XXX.X.XX.X
DIRECTION :
CW
ENDLES : OFF
SPEED : 10°/S
DWELL TIME : 03
SAVE AND EXIT
EXIT
DEFAULT SETTING