ABUS TVCC75200 - Manual (Page 81)

81
9.2 RS-485 Termination
The 1 st DIP of SW2 is used for 100Ω termination.
Set on 1 st DIP of SW2 only by the last connected camera from the loop (CAM n).
Even in case of only one camera, set ON 1 st -DIP of SW2.
9.3 Protocol
The 3 rd , 4 TH of DIP SW2 above are used for Protocol Setting.
Factory Default: Pelco-D or Pelco-P (Auto detection)
DIP SW2 - 3 rd 4 th
OFF / OFF Pelco-D or Pelco-P
ON / ON Maxpro protocol
9.4 Baud Rate Setting
The 7
th , 8 th SW of DIP SW2 is used for baud rate setting.
With DIP SW2 baud rate can be changed to 4800bps, 9600bps.
Factory Default: 2400bps.
DIP SW2-7 th DIP SW2-8 th BAUD RATE
OFF OFF Not Used
OFF ON 2400bps
ON OFF
4800bps
ON ON 9600bps
* The 2
nd , 5 th , 6 th of DIP SW2 are not used.