Alpha Technologies Te25xh - Manual (Page 16)

Argus Technologies Ltd. 029-006-C0 Rev D WC
Printed in Canada. © 2006 Argus Technologies Ltd. ARGUS is a registered trademark of Argus Technologies Ltd. All Rights Reserved. Page 6 of 15
5 Tools Required
Various insulated tools are essential for enclosure and DC power system installation. Use this list as a guide:
• Battery lifting apparatus (as required)
• Various crimping tools and dies, to match lugs used in installation
• Digital voltmeter equipped with test leads
• Cable cutters
• Torque wrench: 1/4” drive, 0-150 in/lbs
• Torque wrench: 3/8” drive, 0-100 ft/lbs
• Insulating canvases as required (2’ x 2’, 1’ x 1’, 3’ x 3’, etc.)
• Various insulated hand tools (see Figure 5) including:
-Combination wrenches -Ratchet and socket set
-Various screwdrivers -Electricians knife
-Fine tipped slot screwdrivers (“tweaker”)
• Battery safety spill kit (required for wet cells only) including:
-Protective clothing -Face shields
-Gloves -Baking soda
-Eye wash equipment
• Cutters and wire strippers (#14 to #22AWG) [2.5 to 0.34mm 2
].
Figure 5–Example of an insulated tool kit