Alpha Technologies Te25xh - Manual (Page 17)

Argus Technologies Ltd. 029-006-C0 Rev D WC
Printed in Canada. © 2006 Argus Technologies Ltd. ARGUS is a registered trademark of Argus Technologies Ltd. All Rights Reserved. Page 7 of 15
6 Enclosure Installation
6.1 Pedestal Mount Kit with Concrete Mounting Frame
This kit is comprised of two kits: 037-146-20 (Brown Kit) and 037-182-20. See drawings 037-146-04 and 037-182-
04 at the rear of this manual.
1. Unwrap the enclosure and inspect the contents. If items are missing or damaged, contact Argus Technologies
and the shipper immediately.
2. Unbolt the enclosure from the shipping pallet.
3. With no less than 2 installation personnel, lift the enclosure off the shipping pallet, and place over the
mounting studs on the pad.
4. Secure the enclosure to the pad using appropriate mounting hardware.
6.2 Pole Mount Kit
See drawing 037-176-04 (037-176-20 Brown Kit) at the rear of this manual, and specific customer-supplied
hardware to be used for mounting in Section 6.2.1.
The pole mount assembly bracket kit includes (where applicable):
• Enclosure mounting hardware
• Pole mount bracket parts (includes safety ring).
NOTE: Ensure that there is sufficient clearance beneath the enclosure mounting for cable routing.
6.2.1 Pole Mount Installation with Customer-Provided Parts
Use a (customer-provided) suspension bolt as shown below. Size: 5/8” x A, where A is the appropriate length for
the stub pole chosen.
Also required (in two places) is a curved washer as
shown below:
Size: 4” x 4” x 1-1/8”
Install pole mount bracket (item 1) onto pole with
suspension bolts, washers and nuts per Figure 6.
The pole mount bracket will be offset from the rear
of enclosure by 100mm (4”).
Mounting (suspension) bolts are to be cut off with
one thread showing past the nut and treated with a
suitable zinc-oxide paint (SKU: 883255) to prevent
corrosion. Both items are required for worker safety
around the pole.
Figure 6–Example of pole mount intallation
(Images are for reference only – subject to installation requirements)
Customer-provided
bolts, washers and nuts