Alpha Technologies INEX 100A STS Module and MBS+PDU - Manual (Page 16)

Argus Technologies Ltd. 019-061-C0 Rev A WC
Printed in Canada. © 2009 Argus Technologies Ltd. ARGUS is a registered trademark of Argus Technologies Ltd. All Rights Reserved. Page 6 of 26
2 Inspection
2.1 Packing Materials
All Argus products are shipped in rugged, double walled boxes and suspended via solid inserts to minimize shock
that may occur during transportation. Packaging assemblies and methods are tested to International Safe Transit
Association standards.
2.1.1 Returns for Service
Save the original shipping container. If the product needs to be returned for service, it should be packaged in its
original shipping container. If the original container is unavailable, make sure the product is packed with at least
three inches of shock-absorbing material to prevent shipping damage.
NOTE: Argus Technologies is not responsible for damage caused by the improper packaging of returned products.
2.2 Check for Damage
Prior to unpacking the equipment, perform a visual inspection and note any damage. Unpack the equipment and
inspect the exterior for damage. If any damage is observed contact the carrier immediately.
In addition to the inverter module (Figure 1), the STS shelf and MBS/PDU panel consists of:
1 2 3 4 5 6 7 8 9
x 1 x 1 x 1 x2 x3 x4 x3 x 1 x8
Figure 3–STS shelf and packing list
1) 1*CAN cable for controller
2) 1*DC Power cable for controller
3) 1*Communication cable
4) 2*23” mounting brackets
5) 3* inter-connection bus bars
6) 4*M6 screws for brackets
7) 3*protect circuit of shelf
8) 1*short jumper
9) 8*M6 screws for bus bar.