B&K Precision 1696-1698 - Manual - Manual (Page 14)

14
and returns to its old settings
Note :
If during any of the above keypad operations, you fall to input a setting within 10 seconds, the unit will cancel the procedure and resume its previous
settings. You can exit any of the above operations by pressing the CLEAR key and the unit will revert to its previous settings.
7. USING THE PRESET FEATURES
PRESET PROGRAM SYMBOLS
Program Unit is ready for inputting of a Preset Program Number (19).
Recall
Unit is ready for recalling a Preset Program Number.
The unit can store nine preset voltage and current settings.
Once programmed, these settings will be retained even when the unit is switched off.
Preset Programming
1. Press PROG key
The display will show Program_
Key in Program Number (1-9) at the keypad
2. The display will show :-
a)
The newly keyed in Program Number.
b) The old settings of voltage and current with V-set ready for voltage to be reset.
c)
Set the required voltage level than press ENTER to confirm.
d) The display will show I-set ready for current level to be reset.
e)
Set required current level then press ENTER to confirm.
f) The program will automatically advance to the next Preset (as shown in the display Program_ section).
g) If you want to change the voltage and current setting of next Preset repeat procedure B to E, otherwise just press ENTER to