B&K Precision 1696-1698 - Manual - Manual (Page 23)

23
If it shows No Connection, check the following:
A. Go back to setup and check to see if the correct COM
port has been assigned.
B. Check the power supply; make sure that the RS-232 has been selected.
C. Check the RS-232 cable connection.
D. Check to make sure that the power supply is turned on.
1. Setting
Once you bring up the software you can your desired sample time from
1 second up from the drop menu.
Data log Sampling Time
You can set your output voltage upper limit value to further safeguard
your low voltage applications.
Voltage Upper Limit Setting
2. Data Log window
A). You can use the Data Log window to view present output data or
stored data.
B). All the parameters at the bottom of the window display can be
changed by direct entry from the PC (with decimal point) and then
confirmed by the Enter key of the PC, or you can select the values
from the respective drop menu.
Parameters at the bottom of the Data Log window:
VMin
Minimum voltage level.
V Max. Maximum voltage level.