B&K Precision 1696-1698 - Manual - Manual (Page 15)

15
go to the next Preset.
Whenever you want to determine Preset Programming you can press the CLEAR key to return to normal operation mode.
Selecting Presets
1. Press the RECALL key
The display will show Recall_
2. Press the number key (1-9).
The display will show the chosen Preset Number, its voltage and current level.
3. Press ENTER to activate .The unit will resume the chosen reset values.
If during any of the above procedures, you fail to input a setting within 10 seconds, the unit will cancel the procedure and resume the previous
settings. You can exit any of the above operations by pressing the CLEAR key and the unit will resume to its previous settings.
7.1 _ Operating the Timed Program
The unit can be programmed to operate up to 20 timed subprograms (1-19 STEP as shown in the display). Each subprogram is capable of running a
preset operation period of 1 second to 99 minutes and 99 seconds with its own preset voltage and cur r ent level. The timed subprogram can be set to run
in sequence repeatedly from 1 to 232 cycles. You can run the unit through the sequence of sub programs for the input cycles number unless interrupted
by pressing the CLEAR key.
Programming the Unit
1. Press the PROG key
2. Press the 0 key (to get to the Timed Program Mode) and the display will show Program 0 StEP-..00
3. Input subprogram number 0 to 19 and press ENTER to confirm.
4. Input voltage level followed by ENTER to confirm and the display will show I-set.
5. Input current followed by ENTER to confirm. The bottom left corner of the display will show Timer00m00s and the appearing minute symbol m.
6. Input minute period (0-99) followed by ENTER to confirm. The bottom left corner of the display will show Timer00m00s and the appearing
second symbol s .
7. Input seconds period (0-99) followed by ENTER to confirm. The timed subprogram will automatically to next subprogram number ready input of
new settings.
8. Repeat procedure 4 to 7.