B&K Precision 2542B-GEN - Manual - Manual (Page 206)

Quick Start Guide
206
6.8 Output Basic Sine Waveform
This application example describes how to use the generator
to output a sine waveform with 10 kHz frequency, 6 Vpp
amplitude and 1 Vdc offset voltage.
Perform the following steps to output the specified sine
waveform.
 Connect the WG Output teminal to CH1 terminal.
 Press ON/OFF key to enable signal output.
 Press the MENU key to display the arbitrary waveform
generator menu.
 Press Output Type softkey to select the Sine waveform.
 Press Freq softkey to select and specify the frequency to
10 kHz.
 Press Ampl softkey to select and specify the amplitude
to 6 Vpp
 Press Offset softkey to select and specify the offset
voltage to 1 Vdc
 Press the GRAPH key to enable the Graph display.